Midea MP10SCWBA2RCM Manuel Utilisateur page 18

LED Display
Shows the set temperature in °C or °F and the "Auto timer" settings.
While on DRY and FAN modes, it shows the room temperature.
Shows error and protection codes :
E1-Room temperature sensor error.
E2-Evaporator temperature sensor error.
E3-Condenser temperature sensor error (on some models).
E4-Display panel communication error.
P1-Bottom tray is full-Connect the drain hose and drain the collected
water away.If the protection repeats, call for service.
Note: When one of the above malfunctions occurs, turn off the unit and check
for any obstructions. Restart the unit and if the malfunction is still present, turn
off the unit and unplug the power cord. Contact the manufacturer or its service
agents, or a similar qualified person for service.
Operation Instructions
COOL Operation
-Press the MODE button until the COOL indicator light comes on.
-Press the ADJUST buttons "+" or "-" to select your desired room temperature. The
temperature can be set within a range of 17°C~30°C/62°F~86°F.
-Press the FAN SPEED button to choose the fan speed.
HEAT operation(for models without cooling only)
-Press the MODE button until the HEAT indicator light comes on.
-Press the ADJUST buttons "+" or " - " to select your desired room temperature. The
temperature can be set within a range of 17°C~30°C/62°F~86°F.
-Press the FAN SPEED button to choose the fan speed. For some models, the fan
speed can not be adjusted under HEAT mode.
DRY Operation
-Press the MODE button until the DRY indicator light comes on.
-Under this mode, you cannot select a fan speed or adjust the temperature. The fan motor
operates at LOW speed.
-Keep windows and doors closed for best dehumidifying results.
-Do not put the duct to the window.
Operation
17