Publicité
sitech
Function
sitech is a proprietary protocol that allows for connection to a Sidereal Technology
TM
SiTech
GOTO controller.
sitech is typically used as a shell startup command (See
The Baud rate of the corresponding serial port should be set to 19200.
When Argo Navis
sitech protocol, it receives its encoder data from the SiTech
interface. Thus, in this configuration, the encoders are not plugged into the Argo Navis
encoder port.
The
SETUP ALT STEPS
encoder step values and encoder direction sense signs as directed by Sidereal Technology.
You should align Argo Navis
Note that you can also interface Argo Navis
shared encoder architecture if you require a closed-loop positioning system. Contact
Sidereal Technology for details.
Argo Navis
User Manual Edition 11, Dec 2014, for
Argo Navis™
is configured to communicate to a SiTech
TM
and
SETUP AZ STEPS
as if it had the encoders attached directly to it.
TM
Argo Navis™
SETUP SERIAL
TM
servo encoders via the serial
menus should be configured to have the same
TM
to the SiTech
TM
™
Model 102/102B, Firmware Vers.3.0.0
).
TM
controller using the
GOTO controller using a
TM
230
Publicité
