Publicité
setups
Function
The setups shell command puts Argo Navis
state. The unit needs to be in the
take place.
When the setups command is issued and the unit is in the
will respond with 'OK'
Navis
TM
While in the setups command processing state, Argo Navis
a time. A line can either be –
•
An empty line, or
•
A setups command line
All setups commands begin with a '#' character. These setups commands are as follows –
•
#Commit : Commit all setup parameters from RAM to non-volatile memory (EEROM
device)
•
#Count : Return a count of how many setup parameters exist
•
#Quit : Leave the setups state and return to the shell
•
#Read : Dump all setup parameters to standard output
•
#Read item_no : Dump the setup parameter specified by item_no to standard output
•
#Write |parameter|value : Write the value for the specified setup parameter to RAM
•
#Version : Return the current firmware version number
All input lines, except #Count, #Read, #Version and #Quit commands, will be responded to
with either –
•
OK
•
ERROR: <MESSAGE>
When setup parameters are #Read, the returned format is parameter|value|comment
Argo Navis
User Manual Edition 11, Dec 2014, for
Argo Navis™
into the setups command interpreter
TM
state in order for command processing to
SETUP LOAD CAT
™
Argo Navis™
SETUP LOAD CAT
processes input a line at
TM
Model 102/102B, Firmware Vers.3.0.0
state, Argo
229
Publicité
