Publicité
servocat
Function
servocat is an unpublished, proprietary protocol that allows for connection to a
StellarCAT ServoCAT
servocat is typically used as a shell startup command (See
Note that StellarCAT recommend that users upgrade the firmware of their ServoCAT
system to allow use of this new protocol. Previously ServoCAT
protocol. Contact StellarCAT for details.
When used in conjunction with the features of
additional benefits over the
an Argo Navis
alignment process, Alt limit checking, horizon checking and audible alarms.
Note that a special serial cable is required for interfacing the ServoCAT
. This serial cable is different to that used to interface Argo Navis
Navis
TM
The Baud rate of the corresponding serial port should be set to 19200.
The red 'DSC' LED on the front panel of the ServoCAT
successful communications between the two devices. When the LED is flashing, it indicates
communication is taking place but that Argo Navis
steady ON, this indicates that Argo Navis
Argo Navis
User Manual Edition 11, Dec 2014, for
Argo Navis™
TM
GOTO controller also running the servocat protocol.
skycomm
ENTER button press from the ServoCAT
TM
SETUP GOTO
protocol, such as the ability to send the equivalent of
TM
is unaligned. When the LED is
TM
has been aligned.
TM
™
Model 102/102B, Firmware Vers.3.0.0
Argo Navis™
.).
SETUP SERIAL
TM
users used the skycomm
, the servocat protocol offers
TM
handpad during the
TM
to the Argo
to a PC.
TM
can be used to diagnose
TM
228
Publicité
