Publicité
Les langues disponibles
Les langues disponibles
SLIDING GATES
T
.2 -
AB
COMPONENTS SUPPLIED WITH THE OPERATOR
Operator (with 2 release keys)
Limit switch plates (with 4 s/s screws 6x8 UNI 5927)
instructions;
warnings; warranty
TO BE PURCHASED SEPARATELY
CZ - rack (with nr.15 spacers+screws 8x25
UNI 5739-8.8+washers 8x17 UNI 6592)
PF80 -
Foundation plate
IF80 - support for fi xed installation
IB80 - support for pivoted installation
Z20 - 20 teeth pinion (IS NOT for AT83 or AT85)
2.
GATE PRELIMINARY CHECKS
!
Warning
current safety rules, especially at points where there is a danger of
crushing or shearing. The gate MUST be easily moved by hand so
that it can be opened in the event of manual release.
Effective installation requires that the gate and its mechanical
features comply with the construction and functional
characteristics of safety and sliding performance.
For this purpose it is necessary to carry out the inspections
indicated below and all apposite interventions.
GATE - must be:
•
rigid, straight and in good condition, without poorly fi xed or
partially detached parts ; without automatic locking devices
(remove any automatic locking devices)
•
If the lower edge of the gate is too low to fi t the rack, it is
necessary to create a new base support (Fig.4).
LOWER RAIL - must be:
The lower rail of the opening wing must be:
•
straight, horizontal (use a spirit level) and in good condition
•
equipped with a LIMIT STOP of the opening wing (
to prevent the gate from slipping out of the rail and
consequently a serious risk of OVERTURNING.
WHEELS - must be:
•
with a diameter at least 120 mm and dimensions suitable
for the lower rail profi le (Fig.4)
•
in good condition and suitable for the gate weight
•
MAX TWO; positioned in the vicinity of the gate ends
If these requirements are not fully met, wheels HAVE TO
BE REPLACED.
UPPER GUIDES - must be:
•
at least 2, fl ush with the gate panel
•
they must prevent the gate from oscillating during operation
•
they shall produce no friction during motion.
Some installation examples are shown in Fig.5.
Fig.5
REF
(
)
Aprimatic
CATALOGUE
NECESSARY
The gate structure must comply with
AT80/E-AT83-AT85
. /
.
Q
TY
CZ
/ 1
/ 2
/ 5x1m
/ 1
/ 1
/ 1
IF80*
/ 1
-
IF80
WARNING
-
USE
Z20
APPLICATION OF A SUITABLE
PROFILE TO THE ATTACHMENT
OF RACK ON THE LOWER BASE
OF THE GATE
Fig.4)
ROUNDED PROFILE
- 14 -
PF80
IB80*
IB80
OR
IS NECESSARY
IB80
ONLY FOR NOT HEAVY GATES
Z20
THE
PINION ALLOWS TO REACH A FASTER
MOVEMENT
WARNING
-
SUITABLE ONLY FOR NOT CONTINUOUS
FREQUENCY OF USE
A MECHANICAL
OPENING STOP
ON GROUND IS
OBLIGATORY
-
"V"
GUIDE
PROFILE
Fig.3
Fig.4
STOP
-
GUIDE
Publicité
