Migatronic SIGMA CORE 300 COMPACT/S Guide De L'utilisateur page 16

Connection and start-up
Assembly of parts in wire feed unit
Software update
• Insert the SD-card
• Turn on the machine
• Wait until the unit indicates
that the update is complete
• Turn off the machine and
remove the SD card
• The machine is now ready
for use
New software will be loaded into power source and all
connected units.
The software can be downloaded from
an SD card. The file system of the SD card must be formatted to
FAT32.
IMPORTANT:
Save the software in the //MIGA_SW/SIGMA/ file structure.
http://migatronic.com to
16
x4
The pressure of the thumbscrew
is adjusted to allow the wire feed
roll just to slide on the wire when
this is stopped at the contact tip