Sub-Zero IT36CIIDLH Mode D'emploi page 9

ST O R A G E
Storage Drawers
C R ISP E R CO V E R
The crisper cover in the upper storage drawer can be slid
closed, left open, or removed.
To remove the crisper cover:
Pull the upper storage drawer all the way out.
1
Raise the front edge of the crisper cover and pull it
2
forward and out of the drawer. Refer to the illustration
below.
D R AWE R DI V I DE R S
To reposition a drawer divider:
To remove a short divider, flex the long divider slightly,
1
then pull upward. Refer to the illustration below.
To remove a long divider, all short dividers must be
2
removed. Pull the long divider up until it stops, rotate
counterclockwise, then pull upward.
To reinstall a long divider, align the grooves with the
3
drawer tabs, rotate clockwise, then slide down.
To reinstall a short divider, position as desired, then slide
4
down.
Crisper cover Drawer dividers
D R AWER R EM OVAL
To remove/reinstall a storage drawer:
To remove, pull the drawer open until it stops. Raise the
1
front of the drawer slightly and pull straight out. Refer to
the illustration below.
To reinstall, raise the front of drawer and place onto the
2
slides. Align the back of the drawer with hooks on the
slide, then align the white pegs at the front of the slide
with holes at the front of the drawer.
IMPORTANT NOTE: For drawer models, the upper drawer
has a control cable that must be disconnected before
removing the drawer. Refer to the illustration below.
Drawer removal Control cable (drawers)
|
subzero.com 9