Sub-Zero IT36CIIDLH Mode D'emploi page 16

C A R E RE C O MM E NDAT I O N S
Cleaning
IN T E R I O R C LE A N I NG
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights and control
panel.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STA INL E S S S T E E L E X T E RI O R
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.
|
16 Sub-Zero Customer Care 800.222.7820
C O N D EN SER C LEAN I N G
CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the grille. Clean the con-
denser every three to six months.
To clean the condenser:
Turn power off at the control panel.
1
Remove the kickplate by extracting the two mounting
2
screws. Refer to the illustration below.
Use a soft bristle brush and vacuum to remove dust and
3
lint from the condenser. To avoid damaging condenser
fins, vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure or damage.
VAC ATIO N S
For extended vacations, turn power off at the control panel.
Empty the unit and block doors open slightly to let fresh
air in and keep interior dry. Water filter should be replaced
before start up.
CONDENSER
SCREW
Condenser location