Default Volume Control For Satellite; Troubleshooting - Marmitek SILVERLINE 8 Mode D'emploi

4. To identify the first digit press each number button
from 0 - 9 (9) until the LED blinks. The number you
pressed is the first digit of the code.
5. Press each number key from 0 - 9 as above to find
the second digit.
6. Press each number key from 0 - 9 as above to find
the third digit. When the third digit has been found
the LED will go off.

4.6. Default Volume Control for satellite

In factory default, in Satellite mode the volume is
controlled by the TV. However, some Satellite tuners
have their own volume control. You can reprogram the
remote so the volume is controlled by the satellite
receiver instead of by the TV.
1. Press and release the TV Mode button (3) - remote
must be in TV mode for this procedure.
2. Press and hold SETUP (8) button until LED remains
on.
3. Release SETUP button.
4. Press and hold the Mute (4) key for approximately 8
seconds. LED will stay off for the 8 second period,
then blink once to indicate volume default
acceptance and then remain off.
5. Remote volume default is now set.
6. If the Silverline 8 Remote was previously controlling
the television volume in SAT mode, it will now
control the volume of the satellite decoder. If it was
previously controlling the volume of the satellite
decoder, it will now control the volume of the
television.

5. Troubleshooting

The remote doesn't work or loses codes entered
• Confirm with your original remote that the
equipment works correctly.
• Make sure that you have pressed the corresponding
mode key of the equipment or device that you
want to control.
• If the listed code does not work, try the
AUTOSEARCH method or enter the next code of
that brand.
• Check that the batteries have the correct polarity
position.
• The programming of the remote requires 2 AAA
Alkaline batteries (new). If the remote looses codes
within a few days/weeks the problem can be solved
by using 2 new batteries.
• If the LED is lit permanently, in general it will be
necessary to replace the batteries.
• Set the remote back to factory default.
How to set the Silverline 8 Remote back to
factory default
• Press and hold SETUP (8) until the LED indicator (2)
lights steadily. Release SETUP.
• Press and release the STOP key (20) twice.
• Press and release the MUTE key (4).
• The LED (2) turns off after few seconds.
REMOTE CONTROL 9