Automatic Code Search For Some Well-Known Brands; Automatic Code Search For All Brands - Marmitek SILVERLINE 8 Mode D'emploi

If your equipment (TV, SAT, etc....) does not respond, try
the other codes for your brand. If it still doesn't
respond, try the manual code search method (4.4
Manual code search).
4.2. Automatic code search for some well-known
brands
If your brand is listed hereafter, you can use the brand
search method (faster than the "manual" and the
"automatic code search").
BRAND
Philips/Radiola/Aristona/Erres
Sony/Panasonic/JVC/Sharp Akai/Toshiba/Daewoo
Thomson/Brandt
Telefunken/Saba/Nordmende
Grundig/Blaupunkt
Nokia/ ITT
1. Turn on the device you want to control.
2. Press and hold SETUP (8) until the LED indicator (2)
lights steadily.
Release SETUP button.
3. Press the mode button (3) that matches the
equipment you wish to control.
The LED (2) blinks once.
4. Enter the code corresponding to your brand, point
the Silverline 8 Remote in the direction of your
equipment, press Prog+ (5) once only. Continue to
point the Silverline 8 Remote at your equipment
until the equipment changes Channel (the remote
control sends an IR signal every second. Please wait
until your equipment reacts). When your equipment
does react, press on the key -/-- (11) to confirm. If
you accidentally miss the code, you can stop the
autosearch by pressing Prog- (5) and by repeatedly
pressing this key return to the right code. Press -/--
(11) to confirm.
Remark: if some functions of your equipment don't
work, you need to try another code for your brand. The
search function starts after the last confirmed code. For
example, if it was 030, the search function starts at
031, and it will keep on trying until the last possible
code.

4.3 Automatic code search for all brands

When searching an unknown code, you can step
through the library automatically (AutoSearch). When
your equipment responds, you can stop the searching
process and store the code you found.
Note: as you can dedicate any appliance (TV, DVD,
SAT...) to VCR, CBL, DVD, CD, ASAT, DSAT or AUX keys,
you need first to enter any 3 digit code for the kind of
appliance you wish to control (found in the code book),
i.e.: If you want to program a SAT under the VCR key,
enter ANY SAT code found in the code book and then
follow the steps below:
1. Turn on the device you want to control.
2. Press and hold SETUP (8) until the LED indicator (2)
lights steadily.
Release SETUP button.
REMOTE CONTROL
CODE
1
2
3
4
5
6
7