Publicité
Les langues disponibles
Les langues disponibles
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
and Adjusting the Traction Cable (page 24)
more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 24)
to an Authorized Service Dealer for service.
1.
To engage the traction drive, squeeze the left
(traction) lever to the handgrip
Figure 21
2.
To stop the traction drive, release the traction
lever.
Checking
Checking and Adjusting
or take the machine
(Figure
21).
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position
(Figure
each speed selection.
for
Operating the
Auger/Impeller Drive
1.
To engage the auger/impeller drive, move back
the lock switch on the lever, then squeeze the
right (auger/impeller) lever to the handgrip
(Figure
23).
g322974
2.
To stop the auger and impeller, release the right
lever.
19
22). The lever locks in a notch at
Figure 22
Figure 23
g322971
g360687
Publicité
