Publicité
Les langues disponibles
Les langues disponibles
Operating the
Handwarmers
Operate the handwarmers as follows:
•
Press the switch to the O
handwarmers.
•
Press the switch to the O
handwarmers.
Figure 17
1. On/Off switch
2. O
position
N
During Operation
Starting the Machine
Note:
Use the battery pack only in temperatures
that are within the appropriate range; refer to
Specifications (page
15).
1.
Ensure that the battery pack(s) are installed in
the machine; refer to
(page
16).
2.
Insert the electric-start key into the control panel.
3.
Turn the key to the A
4.
Turn the key to the O
machine
(Figure
Note:
If the key is turned from O
the O
too quickly, the machine may not start;
N
ensure that the key stops briefly in the middle
A
position.
CCESSORY
position to turn on the
N
position to turn off the
FF
3. O
position
FF
Installing the Battery Pack
position.
CCESSORY
position to turn on the
N
18).
position to
FF
1. Key switch in O
Note:
If the machine is turned on and left idling
or operating without the auger engaged for an
extended period, the motor shutoff timeout will
engage, shutting off the machine. When the
machine shuts off this way it beeps to indicate
that the timeout was engaged.
g026460
Activating ECO Mode
Using ECO mode may extend battery life by reducing
rotor speed; use ECO mode whenever you are
moving light snow, or moving snow a short distance.
Activate ECO mode using the ECO button as shown
in
Figure
19.
1. ECO mode button
17
Figure 18
position
N
Figure 19
g347864
g347866
Publicité
