Publicité
Les langues disponibles
Les langues disponibles
Installation
4
Once the combustion head adjustment is completed:
reassemble the burner 4) on the slide bars 3) at about
100 mm from the pipe coupling 5) - burner in the position
shown in Fig. 11;
insert the probe and electrode cables, then slide the
burner as far as the pipe coupling - burner in the position
shown in Fig. 17;
refit the screws 2) on the slide bars 3);
fix the burner to the pipe coupling with the screw 1).
6463
1
2
3
refit the split pin into one of two slide bars 3).
re-couple the articulated coupling 6) to the graduated sec-
tor 7).
When fitting the burner on the two guides, it is
advisable to gently draw out the high voltage cable
and flame detection probe cable until they are
slightly taut.
CAUTION
4
D8709
14
GB
5
6
7
Fig. 17
Publicité
