Maintenance; Transport And Storage; Technical Specifications - Tunturi C35 Mode D'emploi

MAINTENANCE

The equipment requires very little maintenance. Check,
however, from time-to-time that all screws and nuts are
tight.
• After exercising, clean the equipment with a soft,
absorbent cloth. Do not use solvents.
• Never remove the equipment's protective casing.
• The electromagnetic brake forms a magnetic fi eld
that may damage the mechanism of a watch, or the
magnetic identifi cation strip on a credit or cash card,
should they come into immediate contact with the
magnets. Never attempt to detach or remove the
electromagnetic brake!
• The electromagnetic brake is based on electromagnetic
resistance; resistance level is electronically measured
and shown as watt reading on the display. Due to the
measurement system, your Tunturi crosstrainer need not
be re-calibrated when assembled, serviced and used
according to this Owner's Manual.
MALFUNCTIONS
Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary to
take the whole device in for repair, as it's usually suffi cient
to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer immediately. Always give the
model and serial number of your equipment. Please state
also the nature of the problem, conditions of use and
purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number for
the part you need. The spare part list is at the back of this
manual. Use only spare parts mentioned in the spare part
list.
TRANSPORT AND
STORAGE
Please follow these instructions when carrying and moving
the equipment about, because lifting it incorrectly may
strain your back or risk other accidents:
Always switch the power off and unplug the power cord
before you start moving the equipment around!
For transportation or moving of the device, two grown-ups
are needed. Remain standing in front of the device on
each side and take a sturdy grip at the handles. Lift the
front of the device so as to lift the rear of the device on
the wheels. Move the device and carefully put it down to
its new place.
NOTE!
Transport the equipment with caution over uneven
surfaces, for example over a step. The equipment should
never be transported upstairs using the wheels over the
steps, instead it must be carried. We recommend that you
use a protective base when transporting the equipment.
To prevent the equipment malfunctioning, store in a dry
place with as little temperature variation as possible and
protected from dust.
TECHNICAL
SPECIFICATIONS
Length
Width
Height
Weight
The Tunturi C35 meets the requirements of the EU's EMC
Directives on electromagnetic compatibility (89/336/EEC)
and electrical equipment designed for use within certain
voltage limits (73/23/EEC). This product therefore carries
the CE label.
The Tunturi model C35 meets EN precision and safety
standards (Class B, EN-957, parts 1 and 9) for fi tness
devices. The precision of the capacity measurement is
secured during manufacturing by adjusting the brake
with a dynamometer. Calculation of exercise capacity is
based on rotation speed and moment.
Due to our continuous policy of product development,
Tunturi reserves the right to change specifi cations without
notice.
NOTE!
The instructions must be followed carefully in the
assembly, use and maintenance of your equipment. The
warranty does not cover damage due to negligence of
the assembly, adjustment and maintenance instructions
described herein. Changes or modifi cations not expressly
approved by Tunturi Oy Ltd will void the user's authority to
operate the equipment!
WE WISH YOU MANY ENJOYABLE ENJOYABLE
TRAININGS WITH YOUR NEW TUNTURI TRAINING
PARTNER !
6 6
183 cm
70 cm
170 cm
69 kg