Publicité
Les langues disponibles
Les langues disponibles
English
1. General information
This document is intended for the installer and the end user. After
the system installation and commissioning make sure it is deliv-
ered to the end user or the system manager. The manufacturer is
not responsible for damages resulting from failure to follow these
instructions and those contained in any additional documents
delivered with the system.
Cordivari Stratos Solar Thermal Systems have been designed
and manufactured for producing domestic hot water using solar
energy.
In particular they are recommended for geographic areas with
high annual solar radiation. The system is ready to be installed.
You can perform a multiple installation to extend storage vol-
umes of available domestic hot water, while maintaining the
complete solar energy system efficiency.
Any use of the product other than the one stated in this docu-
ment relieves the manufacturer of any liability and will void any
warranty.
1.1 Symbols used
General hazard
Risk of falling from height
Mandatory eye protection
Protective footwear must be worn
Personal protective equipment against falls
must be worn
Dangerous electrical voltage
Danger: suspended loads
A protective helmet must be worn
Protective gloves must be worn
Context information
1.2 Handling instructions
For proper handling, always consult a specialist.
User manual and assembly instructions
The system must be handled with the utmost care
only when empty, avoiding any shocks and sudden
movements that could damage it and compromise
its water tightness or structural strength.
Do not place any load on the system.
Always ask skilled and well trained personnel to handle the solar
energy system. They should be qualified, experienced and prop-
erly equipped in compliance with the regulations in force.
Use transport means and lifting equipment of adequate capacity
and size.
Always use belts of suitable strength for handling the system, as
shown in the figure.
CAUTION! Do not remove the protective film from
the glass before filling the system
CAUTION! Do not use the inlet and outlet hoses to
handle or lift the solar energy system when it is out
of the package. Do not twist the system.
2. Standards
UNI EN ISO 9488:2001 - Solar energy - Vocabulary
UNI EN 12975-1:2006 - Solar thermal systems and components
- Solar captors - Part 1: General requirements
UNI EN 12975-2:2006 - Solar thermal systems and components
- Solar collectors - Part 2: Test methods
UNI EN 1991:2004 parts 1-2, 1-3 and 1-4 – Actions on struc-
tures, snow loads and wind action
UNI EN 12976-1:2006 - Solar thermal systems and components
- Factory made systems - Part 1: General requirements
UNI EN 12976-2:2006 - Solar thermal systems and components
- Factory made systems - Part 2: Test methods
- 18 -
For manual handling use the proper
carton handles on the package
Cod. 1910000002091 - nv05
Publicité
