Napoleon High Country NZ7000 Instructions D'installation Et D'opération page 30

30
6.6 SMOKE CHAMBER INSULATION PANEL REPLACEMENT
EN
A. Remove screws from brackets and slide
rear panel out of smoke chamber. Repeat
for both side panels. (FIG.1)
B. Remove screws from lower brackets and
remove front lower panel. Then remove
screws from upper brackets and remove
front upper panel (FIG.2)
C. Remove Screws from lower side brackets
and remove the side upper panels
(FIG.3 )
NOTE: Smoke chamber insulation panels are fragile. Handle with care.
D. Slide top panel into smoke chamber and Install the 4 brackets removed in Step C. (FIG.3)
E. Slide front upper panel into smoke chamber then front lower panel and install brackets. (FIG.2)
F. Slide side panels then rear panel into smoke chamber and install brackets. (FIG.1)
W415-1642 / 04.15.16
2
1
6
4
3
FIG.1
7
5
FIG.2
FIG.3