Napoleon High Country NZ7000 Instructions D'installation Et D'opération page 26

26
6.2 DOOR GLASS REPLACEMENT
EN
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS REMOVED,
CHIPPED, CRACKED, BROKEN OR SCRATCHED. CHIPPED GLASS CAN BREAK WHEN EXPOSED TO
HIGH TEMPERATURES. THIS TYPE OF BREAKAGE IS NOT COVERED UNDER WARRANTY.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
WARNING: DO NOT CLOSE DOOR FRAME ONCE DOOR GLASS HAS BEEN REMOVED AS THE
APPLIANCE HAS BEEN FITTED WITH BALANCE WEIGHTS. SEE "BALANCE WEIGHT ADJUSTMENT"
SECTION.
At the end of each burning season inspect the door gasket ensuring that it is not worn or loose. Replace with
proper fi berglass rope. The purpose of door gasketing is to seal the fi rebox. If the doors are not sealed, air leaks
into the fi rebox, creating a quick burning fi re. Replace cracked or broken glass immediately. When reinstalling the
glass, be sure that the glass and gasket create a solid seal around door frame. Follow the instructions below for
glass removal. You may require a fl at tool to gently press the gasket between the glass and the door.
A. Lift the screen up into the appliance.
B. Lower the glass door down and unlatch. Swing
the glass door open.
C. Unscrew the top and bottom retainers inside
door frame. (FIG.1)
D. Remove glass from door frame. (FIG.2)
E. Center and apply gasket to the edge of glass.
Ensure gasket is a continuous loop around the
perimeter of the replacement glass. (FIG.3)
W415-1642 / 04.15.16
!
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION
FIG.2
WARNING
FIG.1
FIG.3