Publicité
Les langues disponibles
Les langues disponibles
Prevention of Cross-Contamination
To help prevent cross-contamination between patients, place a new
hygienic barrier on the sensor for each new patient. The hygienic barrier
must cover the sensor and at least 3-4 in. (7-10 cm) of the cable.
Product Disposal
Dispose of sheaths and other consumables following the normal dental
office procedure for biomedical waste. Improper disposal of biomedical
waste can lead to the spread of illness and disease.
Please contact your dealer or supplier for further information about product
disposal at the end of the product's lifetime.
Recommended Disinfecting Solutions
CAUTION
Holders should be disinfected in an autoclave or with a cleaning agent
after each patient.
Decontaminate the sensor, cable and holders in accordance with CDC – or your
country's (e.g., OSAP) standards – for infection control. Dental Imaging
Technologies Corporation (DITC) recommends wiping the holders with one of
the following cleaning agents.
CaviCide ® (Manufactured by Metrex)
•
•
CaviWipes
•
ProSpray
Sani-Cloth ® Plus, HB (manufactured by PDI)
•
DO NOT:
•
Clean the sensor using non appropriate tools.
The following solutions can be used to decontaminate the holders:
The sensor holders can be disinfected in a steam autoclave using distilled water
at temperature of 275
However, certain restrictions apply:
•
Run the appropriate autoclave cycle according to the
manufacturer's specifications for your specific unit.
English
™
(Distributed by Kerr)
™
(manufactured by Certol)
o
o
F (125
C) at 216 kPa for 12 minutes when bagged.
9
Publicité
