Olimpia splendid ARYAL S2 E DUAL Mode D'emploi Et D'entretien page 46

7.2 - INSTALLATION DIAGRAM
Dual
Uno-Due
4
Trial
Uno-T
Uno-Quattro
• To prevent wall damage, use a stud finder
to locate studs.
• A minimum pipe run of 3 metres is re-
quired to minimise vibration & excessive
noise.
• Two of the A, B, and C air circulation
pathways must be free from obstructions
at all times.
• This illustration is for demonstration
ecautions
purposes only.
• The actual shape of your air conditioner
may be slightly different.
CAUTION
• Copper lines must be independently
To prevent wall damage, use a stud finder to
insulated.
A minimum pipe run of 3 metres is required
to minimise vibration & excessive noise. The installation must be performed in ac-
cordance with the requirement of local and
Two of the A, B, and C air circulation pathways
national standards. The installation may be
must be free from obstructions at all times.
slightly different in different areas.
This illustration is for demonstration
The actual shape of your air condtioner may
be slightly different.
Copper lines must be independently insulated.
NOTE: The installation must be performed in
accordance with the requirement of local and
national standards. The installation may be
slightly different in different areas.
EN - 14
3
Remote
controller
holder
5
Mounting screw
2
ST3.9×25-C-H
Air-break
Installation plate
Switch
Mounting screw
ST3.9×25-C-H
Remote
controller
holder
1
Clip anchor
Air-break Switch
1
2
Drainage
Pipe
5 4 3
Outdoor Unit
Power Cable
The maximum
amount of the
connection cables is 5.
This section is for
reference only.
(1)
Installation
plate
Clip anchor
Refrigerant
pipe
(2)
 