Olimpia splendid ARYAL S2 E DUAL Mode D'emploi Et D'entretien page 38

19. Apply the following checks:
• The size of the room inside which are located the parts containing the refrigerant, are in
accordance with the current quantity of charge of the refrigerant;
• The ventilation device works correctly and the outlets are not clogged;
• The markings on the machine must always be visible and readable, correct them if not;
• The pipelines ore the components containing refrigerant MUST be installed in a place
where no substance may corrode them, unless the components are built with materials
intrinsically resistant against corrosion or are suitably protected against this risk.
20. The refrigerating gases are odourless.
21. For disposal and marking (through signs) of the appliance containing refrigerant gas,
please refer to the local regulations.
22. To store the appliance: The packaging for storage must be resistant in order to avoid
that the appliance may take damage and to avoid the possible leakage of refrigerant gas.
23. Recovered refrigerant must not be discharged in another refrigerating system unless it
has been cleaned and checked.
24. Dismantling MUST be carried out by a qualified technician whom MUST use the PPE
correctly and MUST perfectly know the equipment. All the refrigerants MUST be recovered
safely; always collect a sample of oil and refrigerant before emptying the circuit.
25. Before starting any dismantling operation:
- Electrically insulate the system.
- Ensure that you have mechanical handling equipment at your disposal to handle the
tanks, if necessary.
- The equipment and recovery tanks MUST be in compliance with the standards.
26. The equipment must be labelled indicating that it has been deactivated and emptied of
refrigerant. The label must be dated and signed. Make sure that on the equipment are
present labels indicating that the equipment contains flammable refrigerant.
27. If the compressors or compressor oils must be removed, it is necessary to check that
they have been extracted safely and at an acceptable level to ensure that the flammable
refrigerant has not remained inside the lubricant. The evacuation process must be
carried out before returning the compressor to the suppliers. To speed up this process,
only electric heating of the compressor body must be used.
1.2 - PROPER USE
• The air-conditioner should be used for the exclusive purpose of producing hot or cool air
(on demand) for the sole purpose of obtaining a comfortable temperature in the room.
• Improper use of the machine (outside and inside units) causing damage to persons,
property or animals relieve OLIMPIA SPLENDID of any liability.
1.3 - HAZARDOUS ZONES
• The climate controllers must not be installed in environments with the presence of
inflammable gases, explosive gases, in very humid environments (laundries,
greenhouses, etc.), or in places with other machines that generate a strong heat
source, in proximity of a sources of salt water or sulphurous water.
• DO NOT use gas, gasoline or other inflammable liquids near to the climate controller.
• The climate controller does not have a fan for the introduction of fresh outdoor air into the
room; ventilate by opening doors and windows.
• Always install circuit breaker and a dedicated power circuit.
This product must be used exclusively according to the specifications indicated in this manual.
Use different to that specified, could cause serious injuries. THE MANUFACTURER IS NOT LIABLE
FOR INJURY/DAMAGE TO PERSONS/OBJECTS DERIVING FROM FAILURE TO COMPLY WITH THE
REGULATIONS CONTAINED IN THIS MANUAL.
1.4 - FUSE SPECIFICATIONS
• The appliance is equipped with a safety fuse, the specifications are printed on the board:
T20A/250 VAC (for unit with <24000 Btu/h)
• For units with R32 refrigerant, only use explosion proof ceramic fuses.
EN - 6
-
T30A/250 VAC (for unit with >24000 Btu/h)