NSK Ti-Max X-SG25L Mode D'emploi page 7

CAUTION
• Always keep the bur shank clean. Dirt or debris in the chuck could cause poor bur concentricity or low chuck retention
force.
• Always insert the bur all the way into the chuck. If insertion is insufficient, premature failure of the bearings or accidental
release of the bur may occur.
• Do not exceed Max. Bur Length shown in "10. Specifications".
• Always follow the instructions provided by the bur manufacturer.
• Do not exceed the bur speed recommended by the bur manufacturer.
• Should the handpiece function abnormally during use, stop using the handpiece immediately and contact your Authorized
NSK Dealer.
• Do not use the following fluids to wipe, immerse or clean the product; strong/super acid water, strong acid/alkaline
chemicals, chlorine-containing solutions, solvents such as benzine or thinner.
• The handpiece is delivered in a non-sterile condition and must be autoclaved prior to use.
• Perform regular function and maintenance checks. (Refer to "9. Periodical Maintenance Checks")
• If the handpiece has not been used for a long period, rotate the handpiece and check for noise, vibration and overheating
before use.
All manuals and user guides at all-guides.com
5