NSK Ti-Max X-SG25L Mode D'emploi page 17

8-1 Preparation
1) Wear a eye protection, a mask and gloves to avoid infection.
2) Remove the bur.
3) Disconnect the handpiece from the motor.
8-2 Cleaning
Manual Cleaning (External Surface)
1) Remove dirt and debris on the handpiece surface using a brush under running water (at 38°C or less). Do not use a wire
brush.
2) Wipe off the moisture on the surface using absorbent cloth.
CAUTION
• If water comes inside the handpiece, blow air into the rear of the handpiece using an air syringe and remove the remaining
water.
All manuals and user guides at all-guides.com
15