NSK Ti-Max X-SG25L Mode D'emploi page 13

CAUTION
• Do not use burs other than specified in "10. Specifications" as such burs may be accidentally released or break during
rotation.
• Always keep the bur shank clean. Dirt or debris in the chuck could cause poor bur concentricity or low chuck retention force.
• Always insert the bur all the way into the chuck. If insertion is insufficient, premature failure of the bearings or accidental
release of the bur may occur.
• Do not exceed Max. Bur Length shown in "10. Specifications".
• Do not exceed the bur speed recommended by the bur manufacturer.
• Do not mount or remove the bur until the motor has completely stopped.
• Do not apply excess pressure to the bur as it may break or bend or become difficult to remove.
• After the bur is locked in place, pull and push the bur to make sure the bur is locked.
• Depress the push button until it is almost parallel to the head cap.
• If removing the bur is difficult, grip the bur with fine pliers while depressing the Push-button, and gently remove the bur. This
situation can be avoided by frequently mounting and removing the bur.
All manuals and user guides at all-guides.com
11