Publicité
Les langues disponibles
Les langues disponibles
Reversing the door swing
The glass door can be opened from left to right
and vice versa. Should you desire to change the
opening direction, please follow these instructions.
NOTE
All parts removed must be saved to do the
reinstallation of the door.
1. Remove top cap. Remove the three screws
that hold the upper hinge (right side) to
the top of the cabinet. Carefully remove
top hinge.
2. Lift the door up off of bottom hinge and
place it on a padded surface to prevent
scratching it.
3. Remove the three button plugs from
the upper left corner of the cabinet
and transfer them to the holes on the
opposite side. Be sure to press the button
plugs firmly into the holes.
INSTALLATION
4. Remove three screws that hold the bottom
hinge to lower end of cabinet. Remove the
three button plugs from lower LH corner
and transfer to holes where bottom hinge
was just removed.
5. Unscrew pins
from both hinges
and transfer to
threaded hole
on opposite side.
Re-install bottom
hinge in LH corner
of cabinet using
same three screws
removed in Step 4.
6. On bottom edge of door, transfer door
stop bracket and bushing to holes on
opposite side.
7. On top edge of door, transfer the button
plugs and bushing to hole on opposite side.
Step 9:Change the hinge axis
8. Place bottom LH corner of door onto lower
hinge, then install top hinge to cabinet.
Make sure door is level and it seals
properly against cabinet, then securely
fasten three screws. Snap top cap back
onto hinge.
Chart 6
on the bottom of the
from the right hole to lef
5
Publicité
