Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
This Use & Care Guide provides general
operating instructions for your model. Use
the appliance only as instructed in this Use &
Care Guide. Before starting the Beverage
Center, follow these important first steps.
Location
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• For optimal performance, it is
recommended that you install the Beverage
Center where the ambient temperature is
between 70 and 78 degrees Fahrenheit.
• Allow space around the unit for good air
circulation. Leave a 2 inch space on the
back and sides of the Beverage Center for
adequate circulation.
• Be sure the Beverage Center stays in the
upright position during transport.
• Keep the Beverage Center from any
hazardous or combustible agents.
WARNING
This appliance is intended for use in
residential household and similar interior
applications such as:
• Kitchen / Kitchenette
• Pantry Room
• Basement
• Enclosed Garage
• Other interior residential type environments
NOTE
The exterior walls of the Beverage Center
may become quite warm as the compressor
works to transfer heat from the inside.
Temperatures as much as 30° F warmer
than room temperature can be expected.
For this reason it is particularly important in
hotter climates to allow enough space for air
circulation around your Beverage Center.
Leveling
The Beverage Center must have all bottom
corners resting firmly on solid floor. The floor
must be strong enough to support a fully loaded
Beverage Center. NOTE: It is Very Important
for your Beverage Center to be level in order
to function properly. If the Beverage Center
is not leveled during installation, the door may
be misaligned and not close or seal properly,
causing cooling, frost, or moisture problems.
4
To Level Your Beverage Center:
After removing all interior and exterior packaging
materials, use a carpenter's level to level the
Beverage Center from front-to-back. Adjust the
leveling legs in front, ½ bubble higher, so that
the door closes easily when left halfway open.
Cleaning
• Wash any removable parts of the Beverage
Center interior, and exterior with mild
detergent and warm water. Wipe dry. Do
not use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp
instruments,
appliance surface when removing adhesive
labels. Any glue left from the tape can be
removed with a mixture of warm water and
mild detergent, or touch the residue with
the sticky side of tape already removed. Do
not remove the serial plate.
Important Safeguards: Do not store food in
your Beverage Center as interior temperature
may not get cool enough to prevent spoilage.
In summer months or areas of high humidity,
the glass door may build up moisture. To
remove the moisture, wipe it away.
Handle Installation
1. Set handle over the two mounting studs at
top of door.
2. Use hex head screw driver or allen wrench
to tighten set screws from bottom to
secure handle to door.
which can scratch the
Publicité
