SICK PowerProx Micro-WTT2SL Serie Notice D'instruction page 34

OPERATING INSTRUCTIONS
Response time SIO Logic
Response time IOL
Switching frequency SIO Direct
Switching frequency SIO Logic
Switching frequency IOL
Inverter
Smart Task label
Logic function
Timer function
1) Object with 6% ... 90% remission factor (complies with standard white according to DIN 5033)
2) Equivalent to 1 σ.
en
3) With light / dark ratio 1:1
4) Signal transit time with resistive load
5) Jitter± 20ms
6) A = U -connections reverse polarity protected
B
B = inputs and output reverse-polarity protected
D = outputs overcurrent and short-circuit protected
7) As of T = 45°C a max. output current of I
U
8) NPN off-state current I
9) Footnote teach-in offset 15 mm
10) SIO Direct: Sensor operation in standard I / O mode without IO-Link communication and without the use of sensor-internal logic or time
parameters (set to "direct" / "inactive").
11) SIO Logic: Sensor operation in standard I / O mode without IO-Link communication. Use of sensor-internal logic or time parameters,
additional automation functions.
12) IOL: sensor operation with full IO-Link communication and use of logic, time and automation function parameters.
34 O P E R A T I N G I N S T R U C T I O N S | PowerProx Micro - WTT2SL(C)
= 50 mA is permissible. Below T
max
<= 0.6 mA.
R
WTT2SL-2Xx92
-
-
-
-
-
-
-
-
-
= -10°C a warm-up time is necessary.
U
WTT2SLC-2Xxx9xAxx
typ. 90 ms
11)
typ. 95 ms
12)
5 Hz
10)
5 Hz
11)
5 Hz 12)
YES
Basis logic
DIRECT
AND
OR
WINDOW
Hysteresis
Deactivated
Switch-on delay
Switch-off delay
Switch-on and -off delay
Pulse (one shot)
8021879.1CXK /2022-08-16 | SICK
Subject to change without notice