SICK PowerProx Micro-WTT2SL Serie Notice D'instruction page 25

2.7 Hazard warnings and operational safety
2.8 Repairs
8021879.1CXK /2022-08-16 | SICK
Subject to change without notice
The operating instructions state the following qualification requirements for the various
areas of work:
Instructed personnel have been briefed by the operating entity about the tasks
■
assigned to them and about potential dangers arising from improper action.
Skilled personnel have the specialist training, skills, and experience, as well as
■
knowledge of the relevant regulations, to be able to perform tasks assigned to
them and to detect and avoid any potential dangers independently.
Electricians have the specialist training, skills, and experience, as well as knowl‐
■
edge of the relevant standards and provisions to be able to carry out work on
electrical systems and to detect and avoid any potential dangers independently. In
Germany, electricians must meet the specifications of the BGV A3 Work Safety
Regulations (e.g., Master Electrician). Other relevant regulations applicable in
other countries must be observed.
The following qualifications are required for various activities:
Tasks
Mounting, maintenance
Electrical installation,
device replacement
Commissioning,
Configuration
Operation of the device for
the specific application
Please observe the safety notes and the warnings listed here and in other chapters
of these operating instructions to reduce the possibility of risks to health and avoid
dangerous situations.
The product is a replacement device. The device is not intended to be repaired. Interfer‐
ence with or modifications to the device on the part of the customer will invalidate any
warranty claims against SICK AG.
Qualification
Basic practical technical training
■
Knowledge of the current safety regulations in the workplace
■
Practical electrical training
■
Knowledge of current electrical safety regulations
■
Knowledge of the operation and control of the devices in their
■
particular application
Basic knowledge of the design and setup of the described
■
connections and interfaces
Basic knowledge of data transmission
■
Knowledge of the operation and control of the devices in their
■
particular application
Knowledge of the operation and control of the devices in their
■
particular application
Knowledge of the software and hardware environment in the
■
application
O P E R A T I N G I N S T R U C T I O N S | PowerProx Micro - WTT2SL(C)
OPERATING INSTRUCTIONS
en
25