Publicité
Les langues disponibles
Les langues disponibles
Remove from below the vehicle any protective sealant from the points of contact between the shell and the tow bar;
then paint the uncovered parts with rust preventer.
Disassemble the rear bumper.
1.
Disassemble from the reinforcement crossbeam the polystyrene components and the towing ring.
2.
Remove the reinforcement crossbeam.
3.
Insert components "B" within the spars and fix with reference to screws "1".
4.
For the 2017 models, make a cut on the heat shield (see scheme attached)
5.
Place tow bar "A" with reference to holes "2" and "3" , insert screws and then fix.
6.
Tighten all bolts and nuts with a tightening torque as shown in the enclosed layout.
7.
Connect the wiring to the socket (usually given apart), following the car booklet's instructions "use and main-
8.
tenance" as shown in the enclosed wiring kit layout.
WARNING: PLACE THE WIRING KIT'S CABLE AS FAR AS POSSIBLE FROM THE EXHAUST
9.
PIPE.
Reassemble the polystyrene components on the drawbeam and fasten them with masking tape, silicone or glue.
10.
Reassemble the towing ring and the rear bumper.
11.
INVISIBLE AND SWIVELING SOCKETHOLDER ONLY FOR MODEL "C" AND "VM"
•
Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that the vehi-
cle's towing disposal quoted on the car registration is mentioned on the tow bar document. Otherwise ask for
the appropriate office (umbrarimorchi@umbrarimorchi.it) for explanations or updated documents.
•
For safety, all work involving tow bar installation must be undertaken by skilled technicians.
•
Damaged components must be replaced with manufacturer's spares parts by qualified staff.
•
It is forbidden to make any modification or structural repair to the tow bar.
•
The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be checked at
regular intervals. If the tow ball measures less than 49 mm after selected readings across the diameter, the tow
ball must be replaced with a new one.
•
After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
USE AND MAINTENANCE
Publicité
