Publicité
Les langues disponibles
Les langues disponibles
PrO 3 OzONE SANItAtION SYStEM
The unit has a PrO
3
Ozone Sanitation System installed. The
ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for 30
minutes, and then it will automatically shut off. Thereafter, every
4 hours, the ozone will operate for about 20 minutes.
NOtE: A soft noise is produced by the pump during operation of
the equipment.
PLUMBINg
All Luxury Series baths are factory tested for proper operation
and watertight connections prior to shipping. If leaks are
detected, notify your dealer immediately. Do not install the unit.
WAtER SUPPLY
Consult local authorities for plumbing code requirements in your
area.
IMPORtANt: Proper installation of the fill spout plumbing and
compliance with local codes are the responsibility of the installer.
Jacuzzi
Whirlpool Bath does not warrant connections of water
©
supply fittings and piping, fill systems, or drain/overflow systems.
Nor is it responsible for damage to the bath which occurs during
installation.
CAUtION: A nonflammable protective barrier must be placed
between soldering work and bath unit to prevent damage to the
bath.
CLEAN-UP AFtER INStALLAtION
The acrylic finish will give long-lasting beauty when properly
maintained. To avoid dulling and scratching of the finish,
never use abrasive cleaners or harsh chemicals. A mild liquid
detergent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal tools
will scratch the surface. Spots left by plaster or grout can be
removed if lightly rubbed with a mild detergent and a damp cloth
or sponge.
Minor scratches that do not penetrate the color finish can be
removed by lightly sanding the surface with a 600-grit, wet-dry
sandpaper. To restore the glossy finish, use a special compound
like Meguiar's No. 10 Mirror Glaze. If it is not available, use an
automotive rubbing compound followed by an application of
automotive paste wax.
Major scratches and gouges that penetrate the acrylic surface
may require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer
®
Jacuzzi
©
Whirlpool Bath: Installation and Operation
Page 12
BE76000F • December 2007
Publicité
