Publicité
Les langues disponibles
Les langues disponibles
AIR BAth CONtROL OPERAtION
Normal Mode
Press this button to turn the blower on. The Indicator
light will come on. The blower will turn on for 20
minutes at a constant intensity. The intensity may be
changed by using either the Up Arrow button or the
Down Arrow button.
Pressing this button a second time will turn the
blower off. The control will automatically remember
the last mode used. When the blower is turned
off, the Indicator light will go off and the blower will
continue to run for 10 to 15 seconds to allow the
heater element to cool.
Wave Mode
Press this button to change the blower's power from
a minimum to a user-defined maximum. The blower
intensity will vary from a minimum to the user-
defined maximum and back to the minimum in about
6 seconds to produce a wave effect. The Indicator
light's intensity changes smoothly showing this Wave
mode. Press this button a second time to return to
normal mode where the blower's power is constant.
Pulse Mode
Press this button to change the blower's power
rapidly from the minimum to a user-defined
maximum. The blower intensity is off for about 1.5
seconds then on at the user-defined maximum for
about 1.5 seconds, producing a pulse effect. The
indicator light flashes showing the Pulse mode. Press
this button a second time to return to normal mode
where the blower's power is constant.
toggle Switches
In the Normal mode with the blower power constant,
press the Up arrow to increase or the Down arrow to
decrease. In the Wave or Pulse mode, these buttons
change the blower's intensity to a user-defined
maximum.
Jacuzzi
©
Whirlpool Bath: Installation and Operation
OPERAtION
CLEANINg thE BAth
To clean your bath, simply use a mild, nonabrasive liquid
Indicator
detergent solution. You can protect and restore the gloss to a
light
dulled acrylic surface by applying Meguiar's #10 Mirror Glaze,
a product specifically designed for use on acrylic finishes. If
Meguiar's is not available, an acrylic polish of equal quality or
automotive paste wax is acceptable.
Never use abrasive household cleaners on any Jacuzzi
Whirlpool Bath product.
REPAIRS tO thE SURFACE
Air Bath Controls
Major scratches and gouges which penetrate the acrylic surface
will require refinishing. Ask your Jacuzzi
for special instructions.
PrO 3 OzONE SANItAtION SYStEM
The unit has a PrO
ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for 20
minutes, and then it will automatically shut off. Thereafter, every
4 hours, the ozone will operate for 20 minutes automatically and
continuously.
NOtE: A soft noise is produced by the pump during operation of
the equipment.
tO SEt OzONE tIMER
Determine the best time for the ozone generator to operate. The
ozone generator should be programmed to operate when the
air bath is not in use. Six hours before use, interrupt the power
to the air bath at the dedicated GFCI circuit breaker. Be sure to
observe all safety precautions. When the dedicated GFCI circuit
comes back on, the system is activated and the ozone timer is
set to begin a regular cycle as scheduled.
CAUtION: In the event of a power outage, the timer period will
need to be reset.
Page 1
Whirlpool Bath dealer
©
Ozone Sanitation System installed. The
3
BE76000F • December 2007
©
Publicité
