SOMFY Sonesse Ultra 50 Notice page 7

setting the lower end limit
V
1) Press the button on the control point to lower the
motorised product to the lower end limit.
2) Press the stop button on the control point when the
motorised product reaches the desired lower end limit.
Looking from the point of view of the motor head:
• If the motorised product lowers on the left-hand
side of the motor head, press the white button to
unlock it: the lower end limit is set.
• If the motorised product lowers on the right-hand
side of the motor head, press the yellow button to
unlock it: the lower end limit is set.
Refit the protective housing.
The end limits are set.
2.4. tiPs and reCommendations for installation
2.4.1. questions about the sonesse ultra 50?
Observations
The wiring is incorrect.
The motorised
The motor is in thermal protection. Wait until the motor cools down.
product does not
operate.
The control point is not compatible. Check for compatibility and replace the
The motorised
The drive wheel and the crown
product is noisy:
are not suitable for the tube.
The motorised product is
compressed between the brackets
The tube contains swarf and
screws.
The motorised
The end-limits of the motorised
product stop to soon
product drift.
or to late.
Copyright © 2014 Somfy SAS. All rights reserved.
All manuals and user guides at all-guides.com
Possible causes
Images not contractually binding
1)
2)
Solutions
Check the wiring and modify it if
necessary.
control point if necessary.
Replace the drive wheel and the crown
Increase the play between the brackets
Clean the roller tube.
Readjust the end-limits
EN
7