Publicité
Les langues disponibles
Les langues disponibles
Installation instructions for autotransformer
FK 4000-R
General remarks
Adapter kit
comprising
Fig.1
(1)
(2)
(3)
(4)
(5)
(6)
Procedure
1.
2.
3.
4.
5.
6.
Warning! Work that is not carried out correctly can cause serious damage and
injury. The actions described below may ONLY be carried out by skilled, trained
technicians! Observe and follow the "Safety rules" in the "Operating Instructions"
manual for the power source.
Warning! An electric shock can be fatal. Before opening up the machine:
-
Shift the mains switch of the power source into the "O" position
-
Unplug the power source from the mains
-
Affix an easily readable and understandable warning sign to prevent machi
ne from being switched back on.
Upon opening up the machine discharge any live components, if available (e.g.
electrolytic capacitors).
(1)
(3)
(2)
(5)
(6)
(4)
Autotransformer adapter kit
1 off
Autotransformer FK 4000-R
4 off
Self-tapping pan head screws
1 off
Autotransformer cover
3 off
Plastic rivets
4 off
Serrated lock washers
1 off
Adapter plug
Remove the side panel
Remove the blade connector X2 from the wiring harness.
Remove the break-out section from the vent panel using a screwdriver.
Fit the autotransformer FK4000-R (1) using self-tapping pan (2) head screws and
(5) serrated lock washers so that the 0-200-230 blade connector strip points to-
wards the pump.
Connect the OV interconnecting cable (from terminal X1/pin 5) on the autotransfor-
mer to the OV blade connector lug.
Depending on the mains voltage, connect the 200 – 230V interconnecting cable
(from Molex X10/Pin 15) on the autotransformer to the 200V or 230V blade connec-
tor lug.
1
33.0030.0054
42.0401.0817
42.0409.2632
42.0407.0478
42.0407.0312
43.0003.0308
Publicité
