Trafimet SACIT Pantera Manuel D'utilisation Et D'entretien page 6

EN USER AND MAINTENANCE MANUAL
Introduction
This manual is made of 2 parts:
1 - "PANTERA" AUTODARKENING MASK
2 - COMPLETE "PANTERA AIR SYSTEM"
1. PART 1 - "PANTERA" AUTODARKENING MASK
1.1 Summary
The PANTERA autodarkening welding mask is a new generation welding helmet integrating some
of the most innovative technologies such as digital LCD, optoelectronics detection with 4 sensors
and very wide viewing area, solar power and litium batteries, microelectronics, and True Color ADF
technology.
The PANTERA automatic welding mask is equipped with an ADF filter with digital regulations, for an
easy and fast adjustment of all functions.
The main functions are: MIG/MAG, TIG, PLASMA CUTTING, GOUGING and GRINDING.
The mask ergonomy has been studied to guarantee an excellent protection of head/neck/ears.
Read and understand all instructions before using.
• Be sure that the DIN of the welding mask filter is the correct shade number for your application.
• The PANTERA autodarkening welding mask and filter are not suitable for overhead welding
applications, laser welding, or laser cutting applications.
• The PANTERA autodarkening welding mask is designed to protect the eyes and face from
sparks, spatter, and harmful radiation under nor-mal welding conditions.
• The PANTERA autodarkening welding mask will not protect against explosive devices or
corrosive liquids. Machine guards or eye splash protection must be used when these hazards are
present.
• Impact resistant, primary eye protection, spectacles or goggles that meet current ANSI
specifications, must be worn at all times when using this welding helmet.
• Avoid work positions that could expose unprotected areas of the body to spark, spatter, direct
and/or reflected radiation. Use adequate protection if exposure cannot be avoided.
• Before each use, check that the protection plates are clean and that no dirt is covering the
sensors on the front of the filter.
• Inspect all operating parts before each use for signs of wear or damage.
• Any scratched, cracked, or pitted parts should be replaced immediately.
• Do not make any modifications to either the welding filters or helmet, other than those specified in
this manual.
► Do not use any replacement parts other than those specified in this manual,
Unauthorized modifications and replacement parts will void the warranty and expose the
user to the risk of personal injury.
►If this lens does not darken when the arc is ignited, stop welding immediately and contact
the manufacturer's representative.
►Do not immerse this filter in water: this model is not water proof.
►Do not use any solvents on any filter or helmet components.
► The recommended operating temperature range for welding filter is -5°C (23°F) – +55°C
(131°F). Do not use this device beyond these temperature limits.
• Failure to follow these warnings and/or failure to follow all of the operating instructions could
cause severe personal injury.
6
WARNING