Trafimet SACIT Pantera Manuel D'utilisation Et D'entretien page 15

Warning sound indication
Each grid stands for a period of 100ms. Gray is the beep sound and blank grid is a quiet period. If
several continued grids are in gray then there's a continuous beep sound.
For example, when the current is overloaded, the system sounds like beep~beep~beep~~~~~.
Install the battery
Turn on the system
Change the air flow
speed
Turn off the system
Current overload
Air outlet jam
Over heat
Low battery
Filter jam
7. TROUBLE SHOOTING
Problem
Fault code «E01»
+ warning blinks
Fault code «E02»
+ warning blinks
blinks
+ warning blinks
+ alarm sounds
blinks
+ warning blinks
+ alarm sounds
blinks
+ alarm sounds
100ms per grid
0 1 2 3 4 5
Probable cause
1. Motor is stuck
2. Motor is damaged
3. Blower structure failure
caused by outer force
4. Circuit failure
1. Motor is damaged
2. Motor impeller rubs blow-
er shell
3. Circuit has excessive
current.
Low battery
Filter blocked
Tube blocked
Battery high temperature
6 7 8 9 10
Action
Check and remove physical failure
and restart the system. Return to
dealer if LCD still shows E01
Check and remove physical failure
and restart the system. Return to
dealer if LCD still shows E02
Charge the battery
Remove obstruction, change the filter
Clean tube
Stop working and rest
15