Tivoli Audio Music System Two+ Mode D'emploi page 9

unlistenable stations listenable. Regardless of the previous audio setting, the SpacePhase
Wide mode will automatically engage each time the Music System Two+ is turned on.
EQ: To temporarily turn the EQ off, press and hold the Audio button. The display will show "EQ
Off" and a confirmation beep will sound. The EQ will engage again automatically the next time
the Music System Two+ is turned on. To keep the EQ off, press and hold the Audio button and
the display will show "EQ Always Off" and a confirmation beep will sound. The EQ will remain
off until "EQ On" is selected. The EQ differs from Audio in that it enhances lower frequencies
primarily at lower volume levels. We suggest the rear Bass level be set to the center detent
position. Should the bass ever sound distorted, immediately lower the bass level and/or volume.
11. SNOOZE/MUTE (Top of Cabinet): When the Alarm activates, press this button to silence the
alarm for 7 minutes. The display will count down the remaining Snooze time. Adjusting the
volume level will cancel the Snooze mode. During normal operation, press this button to mute
the audio. The display will show "Muted". Press again to restore the audio output or adjust the
volume level.
12. HEADPHONE OUT: Connect a set of headphones (not included) to this variable stereo output
for private listening. Plugging in the headphones will mute the primary speakers. The head-
phone's volume is adjusted using the front panel volume knob. This stereo output accepts
a 3.5 mm stereo male mini connector. Avoid using headphones at high volume levels to prevent
possible hearing damage.
13. IR SENSOR: Receives signals from the included remote control. Do not obstruct this sensor.
Guide To Features (Rear Panel)
1. ANTENNA SWITCH: Switch between the internal and the external DAB/FM antenna.
2. EXTERNAL ANTENNA: An external telescoping antenna is affixed to this input. Adjust for
best reception. For more, see the section marked "Reception/RDS".
3. AUX IN: To hear audio from another device such as a TV or MP3 player, connect said device's
audio output to this stereo input and set the Source button to AUX. Switching to the Auxiliary
position does not turn on the connected device. This stereo input accepts a 3.5 mm stereo male
mini connector. Note you may need to adjust the volume level differently for an auxiliary device
than the level used for radio listening.
4. MIX IN: Connect your computer's (or other device's) audio output to this input to hear its audio
mixed in with the tuner or auxiliary device if one is connected. The volume level of this input
must be adjusted at the source. This input accepts a 3.5 mm male stereo mini connector.
All manuals and user guides at all-guides.com
8 6 3 4 5
ANTE NNA
DAB/FM ANTENNA
1 2 7
™
9 – ENGLISH