Tivoli Audio Music System Two+ Mode D'emploi page 10

5. REC OUT: You can record from the Music System Two+ by connecting a cassette deck's audio
input (or other recording device) to this fixed level stereo output. The primary speakers will not
be muted when using this output. This jack accepts a 3.5 mm stereo male mini connector.
6. BASS LEVEL: Turn this control knob to the right to increase the bass volume level or to the
left to decrease the bass volume level. The subwoofer is designed to subtly augment the lower
bass frequencies, not overpower the sound. Tivoli Audio recommends setting this knob to the
center detent position. If the bass should ever sound distorted, immediately lower the bass
level control and/or the front volume control.
7. POWER INPUT: Connect the supplied power cord to this input and plug the cord into a wall
outlet not controlled by a switch. If the power cord is removed from the unit or unplugged from
the wall outlet, please wait 60 seconds before plugging the cord back into the Music System
Two+.
8. BATTERY COMPARTMENT: Properly install the included "AA" batteries to maintain the clock
and alarm settings during a power outage. Check the batteries annually. The display will show
"No Batteries" if there are no batteries installed or the batteries have no or low power. Dispose
of spent batteries according to your state/country's regulations. When operating on the battery
back-up power, the Music System Two+'s display and LEDs will not illuminate in order to
conserve power, but if set, the alarm will still sound at the designated time. In such a case, the
tone will sound instead of the radio to further conserve battery power.
Remote Control (Remove clear tab over battery before use)
In addition to duplicating most of the front panel controls, the remote control adds the following
functions:
1. MENU/SELECT: Press and hold to enter the main
menu within each source mode and press briefly to
select items within the menu. Use the Volume pq but-
tons to navigate menu items. For more, see the
sections marked "DAB Menu" and "FM Menu".
2. DISPLAY: When in DAB mode, briefly press repeatedly
to view audio, signal strength, frequency, signal error,
and bit rate. In FM mode, view audio, signal strength,
PTY (Program Type, if any) and frequency.
Controlling volume via the remote is performed using the
pq arrow buttons, while DAB and FM tuning is controlled
using the Left and Right arrow buttons.
When operating the remote control at close distances the
display might pulse. This is normal and is a direct result of
the remote's ability to operate at greater distances.
When it comes time to replace the remote control's battery,
use a 3V Lithium Cell #CR2025, installed with the positive
side facing the bottom side of the remote.
DAB/DAB + /DMB Menu
In DAB Mode, press and hold the volume knob on the Music System Two+, or press and hold the
Menu button on the remote control, to enter the main menu. Rotate the knob and press in to change
the items within the menu or use the Remote pq buttons and Select button.
10 – ENGLISH
All manuals and user guides at all-guides.com
1
SELECT
MENU
MUSIC SYSTEM TWO
2