Tivoli Audio Music System Two+ Mode D'emploi page 7

Les langues disponibles

Guide To Features (Front Panel)

1. POWER: Push to power the Music System Two+ On or Off (Standby).

2. VOLUME/MENU/TREBLE: Rotate clockwise to increase the volume or counter-clockwise to

decrease the volume. The volume level is represented in numbers from 0 (no output) to 30

(maximum output). If the volume ever sounds distorted, reduce the level immediately. In DAB

and FM modes, push and hold the knob to access the menu. See the sections marked "DAB

Menu" and "FM Menu". Push briefly and rotate counter-clockwise to reduce the treble or

clockwise to increase the treble. Press the volume knob in to set or the setting will store auto-

matically and the display will return to its previous state. This knob is also used to adjust and

enter selections (by pushing the knob in) when setting the Clock and Alarms. Adjusting the

volume during Snooze will cancel the Snooze mode.

3. ALARM 1/ALARM 2: Briefly press and hold Alarm 1 or 2. A beep will confirm you are in the alarm

set-up mode and the corresponding green LED will illuminate. Rotate and press the Volume knob

in to adjust and set the hour (Figure 1) and minutes (Figure 2) and press in to set and move to the

next setting. Note, adjusting the hour does not affect the minutes and vise-versa. Set the alarm

source (Figure 3 and 4) and alarm volume (Figure 5) in the same manner. If you want the alarm to

wake to a particular station, you must press and hold the alarm button while in DAB or FM mode

to be able to set the alarm to wake to a specific station. Setting the alarm to wake to DAB or FM

when the unit is in AUX/BT mode or in standby will not allow setting a specific station. Setting the

alarm source to "AUX" will cause the alarm to wake to a tone. Bluetooth cannot be selected as an

alarm source. When the alarm LED is off, press the Alarm button once to set the alarm. The display

will show the time the alarm is set to wake. When the alarm LED is on, press the Alarm button

briefly to turn it off. If the alarm is set and power is lost, the alarm will still sound (the tone will sound

in place of radio) at the designated time provided fresh batteries are correctly installed in the rear

battery compartment. When the alarm activates (Alarm LED flashes) you may either turn the unit

off and keep the alarm set for the next day, press the Snooze button to temporarily mute the alarm

for 7 minutes, or briefly press the Alarm button to cancel activation, turning the unit off, and keeping

the alarm set to wake the next day. Adjusting the volume during Snooze will cancel Snooze mode.

All manuals and user guides at all-guides.com

CLOCK

SLEEP

ALARM 1

ALARM 2

SOURCE

POWER

–

TUNE

AUDIO

7 – ENGLISH