Tivoli Audio Music System Two+ Mode D'emploi page 8

Fig 1, 2, 3, 4, 5
4. CLOCK: Press and hold to set. A beep will confirm you are in the clock set mode. Use the
volume knob to select the hour (Figure 6) and then press the volume knob in to set and cycle to
the minutes (Figure 7). Adjusting the hour does not affect the minutes and vise-versa. Repeat
this process to set the year, month and the day (Figure 8, 9 and 10). Once set, press the Clock
button briefly to recall the date and time whenever DAB, RDS or Bluetooth mode is displayed.
When the date is shown, only the month and day will show (not the year).
Fig 6, 7, 8, 9, 10
5. PRESETS 1–6: Press and hold to memorize the tuned station to that particular preset. A beep
will sound confirming the station has been successfully stored. Press briefly to recall the sta-
tion associated with that preset. There are 6 DAB presets and 6 FM presets. If a Preset button
is pressed but no station has been set, the display will show "Preset Empty" for 2 seconds. A
station's preset number will only show on the display when the Preset button is pressed. The
same station cannot be saved to more than 1 preset.
6. SOURCE: Briefly press to cycle through the sources: DAB, FM, Auxiliary and Bluetooth. The source
can't be changed while the alarm is sounding.
7. BLUETOOTH: Press to activate Bluetooth wireless technology and follow the steps outlined
under the "Bluetooth Operation" section.
8. SLEEP: With the Music System Two+ playing DAB, FM, Bluetooth or an auxiliary device, briefly
press to begin the 20 minute Sleep timer. The corresponding green LED will illuminate while the
Sleep timer is active and the display will countdown the remaining Sleep time. The Music System
Two+ will power off automatically at the end of the Sleep cycle. Note DAB and RDS text will not
be displayed in Sleep mode.
+
– :
9. TUNE / In DAB mode, use these buttons to show all available DAB/DAB+ stations. Use
the +/- buttons to highlight specific stations and the highlighted DAB station will tune automati-
cally after 3 seconds, or press the Enter button on the remote control.
FM: Press the Tune +/- buttons briefly to Auto Scan to the next station detected. See "Scan
Setting" under "FM Menu" on how to disable Auto Scan and tune stations manually.
10. AUDIO: Push briefly to cycle through Stereo, SpacePhase
The SpacePhase Wide mode setting is designed to create a more expansive soundstage,
™
while the Mono setting reduces multiplex noise on weak FM stations, making otherwise
8 – ENGLISH
All manuals and user guides at all-guides.com
Wide mode, or Mono audio settings.
™