Compact Wireless-G Broadband Router
NOTE: For all products, the Declaration of Conformity (DofC) is available through one or more of these options:
•
A pdf file is included on the product's CD.
•
A print copy is included with the product.
•
A pdf file is available on the product's webpage. Visit www.linksys.com/international and select your country or
region. Then select your product.
If you need any other technical documentation, see the "Technical Documents on www.linksys.com/international"
section, as shown later in this appendix.
The following standards were applied during the assessment of the product against the requirements of the Directive
1999/5/EC:
• Radio: EN 300 328 and/or EN 301 893 as applicable
• EMC: EN 301 489-1, EN 301 489-17
• Safety: EN 60950 and either EN 50385 or EN 50371
Dynamic Frequency Selection (DFS) and Transmit Power Control (TPC) are required for operation in the 5 GHz band.
DFS: The equipment meets the DFS requirements as defined in ETSI EN 301 893. This feature is required by the regulations
to avoid interference with Radio Location Services (radars).
TPC: For operation in the 5 GHz band, the maximum power level is 3 dB or more below the applicable limit. As such, TPC is
not required. Nevertheless, you can further reduce the power output if you wish to do so. For more information about
changing the power output settings, refer to your product's documentation on its CD or www.linksys.com/international.
CE Marking
For the Linksys Wireless-N, -G, -B, and/or -A products, the following CE mark, notified body number (where applicable),
and class 2 identifier are added to the equipment.
or
Check the CE label on the product to find out which notified body was involved during the assessment.
Appendix I: Regulatory Information
All manuals and user guides at all-guides.com
or
or
75