Scheppach MR760-E Traduction Des Instructions D'origine page 43

11.4 Starting the motor (Fig. 12)
1. Sit on the driver's seat (2).
2. It is activated by fully depressing the brake pedal
(8) and pressing the locking brake (14).
3. Turn the ignition key (30) in the ignition lock (23) to
"ON". The control panel begins to illuminate.
11.5 Driving with the mowing unit switched off
(Fig. 13)
1. Lift the mowing unit (6) to the highest level.
2. Depress the brake pedal (8) to release the locking
brake (14).
3. The battery-powered ride-on lawnmower moves
forward when the forward pedal (10) is pressed
carefully.
4. In order to stop, step off the forward pedal (10) and
press the brake pedal (8).
5. The battery-powered ride-on lawnmower moves
backwards when the reverse pedal (15) is pressed
carefully.
6. In order to stop, step off the reverse pedal (15) and
press the brake pedal (8).
Note: When the brake pedal is pressed, the device
cannot receive signals from the forward or reverse
pedal.
11.6 Mowing
m WARNING!
Danger of accident when reversing!
Be aware of the rear environment when reversing!
- Reverse only if necessary!
Hints for mowing
• Before each mowing operation, check that the
mowing blade is correctly attached, in good con-
dition and well sharpened. Always wear protective
gloves when doing this!
• Check the mower, mowing blade and other parts if
you have driven into a foreign object or if the device
vibrates more than normal.
• Only mow when there is sufficient light.
• Watch out for traffic on or near a road. Keep the side
discharge away from the road.
• Avoid mowing in places where the wheels have
trouble gripping or mowing is unsafe in any other
way.
• Make sure that there are no persons or animals in
the vicinity when reversing.
• Only cut with sharp, flawless mowing blades so that
the blades of grass do not fray and the lawn does
not turn yellow.
• To achieve a clean cut, guide the lawnmower in the
straightest possible paths. These strips should always
overlap by a few centimetres so that no patches remain.
• Keep the underside of the mower housing clean
and be sure to remove grass debris. Grass deposits
make the starting process more difficult, impair cut-
ting quality and grass discharge.
11.6.1 Adjusting the cutting height (fig. 8)
m Attention! The cutting height may only be ad-
justed when the mower is shut off.
Set the cutting height depending on the actual length
of the lawn. Carry out several passes so that a maxi-
mum of 4 cm of lawn is removed at a time.
1. Engage the cutting height adjustment lever (4) to
the desired cutting height.
2. 7 different cutting heights can be set.
IMPORTANT: For transport, the cutting tool must al-
ways be placed in the highest position (level 7).
11.6.2 Mowing / Starting with the mowing unit
switched on
m WARNING!
Risk of injury and damage!
Objects can be ejected and may hit and injure per-
sons. Solid objects can damage the product.
In addition, small stones or other objects can be
ejected at least 15 meters. This can damage cars,
houses, and windows.
- When mowing, keep a distance of 30 metres be-
tween bystanders or animals.
- Do not remove objects from footpaths etc. with the
product.
NOTE!
Risk of damage!
If the product is not cleaned on a regular basis, grass/
weed residues may become trapped below the pro-
tection shield and may block the product. This can
impair the performance of the product and damage it
in the long run.
- Clean the product thoroughly after each use.
1. Pull the mowing unit on/off knob (17) up. The
mowing unit switches on.
2. Release the locking brake (14) by pressing the
brake (8)
3. Pressing the forward pedal (10) starts the bat-
tery-powered ride-on lawnmower with the mowing
unit switched on.
4. Activating the cruise control (22) moves the mow-
er at a speed set for mowing when the mowing unit
is switched on.
5. To stop the device, depress the brake pedal (8).
11.6.3 Working on slopes
m WARNING!
Danger due to errors when driving on slopes!
Take special care when driving on slopes! There is no
"safe" slope. Pay particular attention to the following
safety instructions!
- If the wheels should spin or if the vehicle gets stuck
when climbing a slope, disengage the mowing unit
and attachment devices. Then slowly descend and
leave the slope in a straight direction!
www.scheppach.com
GB | 43