PR electronics 9203 Mode D'emploi page 29

All manuals and user guides at all-guides.com
The following operations should only be carried out on a
disconnected device and under ESD-safe conditions:
Repair of the device and replacement of circuit breakers
must be done by PR electronics a/S only.
Do not open the front plate of the device as this will cause
damage to the connector for the display / programming front
PR 4501. This device contains no DIP-switches or jumpers.
triangle with an exclamation mark: Read the manual before installation
and commissioning of the device in order to avoid incidents that could
lead to personal injury or mechanical damage.
the CE mark proves the compliance of the device with the essential
requirements of the directives.
the double insulation symbol shows that the device is protected by
double or reinforced insulation.
Ex devices have been approved according to the ATEX directive for
use in connection with installations in explosive areas. See installation
drawings in appendix.
DEFinitionS
hazardous voltages have been defined as the ranges: 75...1500 Volt DC, and
50...1000 Volt AC.
technicians are qualified persons educated or trained to mount, operate, and
also troubleshoot technically correct and in accordance with safety regulations.
operators, being familiar with the contents of this manual, adjust and operate
the knobs or potentiometers during normal operation.
22
General mounting, connection and disconnection of wires.
Troubleshooting the device.
Symbol iDEntiFiCation
SaFEty inStRUCtionS
9203 - Product Version 9203-001
WaRning
WaRning