cecotec Mambo 12090 Manuel D'instructions page 51

E3 warning Content exceeded
E4 warning The temperature
is too high.
E5 warning The motor's
temperature is
too high.
E6 and E7 The change in
warnings speed could
not be done
successfully.
E8 warning Wrong NTC sensor
reading
E12 Maximum weight
warning exceeded
E14 Linking process
warning error.
7. MOBILE APP
- Mambo Cecotec 12090 food processor has a Smartphone App that connects the device
through Wi-Fi and allows complete control of the cooking processes. To learn how to use
the App, please refer to the enclosed operating manual for the device and the App.
- To download the App use the enclosed QR code.
There is too much food
inside the jar.
There is no or very little
food in the jar and the set
temperature is too high for
too much time.
The robot has been
operating with too much
food for a lot of time.
Speed change between low
level (1-5) and high level
(6-10) was blocked.
The maximum
measurement value has
been exceeded.
An error occurred at some
point of the linking process.
ENGLISH
Remove some food from
inside the jar or cut the food
to smaller pieces and restart
the machine.
Add food in the jar.
Stop operating the machine
and allow it to cool down
before restarting it again.
Remove the jar, turn the
fixing bracket manually and
place the jar again in place.
Restart the robot.
Please, contact the Technical
Support Service of Cecotec
at +96 321 07 28.
Remove weight from the
scale until it reaches a value
below 4999 g.
Switch it off. Start the linking
process again. If the problem
continues, contact the
Technical Support Service of
Cecotec +34 96 321 07 28.
51