Publicité
Les langues disponibles
Les langues disponibles
POSSIBLE INCONVENIENCES AND SOLUTIONS
The following inconveniences can be fixed up by the operator himself. If the engine does not start, check
in the following order that:
– the fuel tank is at Ieast half full;
– the starting device is operating (when the engine is cold) fig. 5;
– fuel gets to the carburetor;
– the breather hole on the tank plug is not obstructed;
– the air filter is clean (fig. 3);
– current gets to the spark plug (fig. 7). If current does not arrive, after checking the electric cables have
no defects and the plug is clean, change the plug taking care to buy another one with the same heat
rating. If this attempt also should turn out to be useless, the failure must be searched in the magneto
flywheel; at this point it is advisable to go to the nearest service-centre.
MAINTENANCE AND LUBRICATION
An efficient maintenance and a proper lubrication contribute to keep the machine in perfect working order.
LUBRICATION:
Do the following operations with machine in horizontal position.
N.B.: the oil change must be effected with warmed up machine in order to help the total oil drainage.
ENGINE OIL
Follow the instruction on the "Engine operator's manual" carefully. It is however necessary to check the
oil level every 4 hours taking the plug off (fig. 8 n° 1) and checking that oil reaches the hole border. Change
lubricant the first time after 20 hours. Then change it every 50 hours.
Unscrew the plug (fig. 9 n° 1-2)
GEARBOX OIL:
Check oil level every 50 working hours unscrewing the screw (fig. 9 no. 3). lf necessary add some SAE
85W/90 lubricant. Change oil once per year. To drain the oil unscrew the plug (fig. 10 no. 1).
MAINTENANCE:
After the first working hours, it might be necessary to check and adjust the wheel releasing cable and the
reversing device cable acting on the adjuster situated on the handle (fig. 2).
The quick coupling must be always clean and greased.
To remove the fairing pull upward. The same for the cutter bar conveyor.
Spare parts we recommend to have in stock:
– 1 accelerator cable
– 1 wheel engaging cable
– 1 gas throttle lever
– 5 blade fingers
– 1 complete blade
– 10 cutter bar nails
– 2 cutter bar fingers
– 10 cutter bar finger nails.
HOW TO ORDER SPARE PARTS:
Address to your area agent or representant in your Country. Always give the machine seriai number and
part number.
END OF SEASON MAINTENANCE
Wash the machine carefully: change the oil in the gearbox housing, clean the air filter, wash the cutter
bar and grease it.
All manuals and user guides at all-guides.com
10
Publicité
