Télécharger Imprimer la page

Renfert Silent TS 2 Guide De Démarrage Rapide page 14

Masquer les pouces Voir aussi pour Silent TS 2:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Replacing the Fine Particle Filter
Examine and replace the fine particle filter (6) on a regular basis,
at least once a year. It must always be replaced if the dust draw-
en
er symbol (33, Fig. 2) blinks, despite a new dust bag having just
been replaced.
There is a risk of increased exposure to dust when replacing the
fine filter.
That's why the following measures must be taken:
⇒ Keep the plastic bag ready that contains the new filter.
⇒ Keep an additional dust extraction device or suction tube from
another workbench extraction unit ready.
⇒ Wear at least an FFP2 mask for respiratory protection.
⇒ Pull the upper front panel (4, Fig. 1) forward and off.
⇒ Turn the fine particle filter in an anti-clockwise direction to re-
lease it.
⇒ Pull the fine particle filter straight forwards.
⇒ Place the fine filters immediately in the plastic bag and seal the bag tightly to prevent dust escaping.
⇒ Ensure proper disposal.
⇒ Install a new fine filter and fully insert it over the holder bar (25).
⇒ Turn the fine particle filter in a clockwise direction and hand- tighten it in place.
⇒ Inspect the seal on the front panel for damage and replace it, as required.
⇒ Snap the front panel back in place.
⇒ Use the additional dust extraction device to suction up dust that has been released.
Errorcodes
If an error code is displayed during operation or in diagnostic mode, please consult the full set of operat-
ing instructions on the internet for the relevant information on the required course of action.
Spare parts
You can find components subject to wear and the spare parts on the spare part
list in the internet at www.renfert.com.
Enter the following item number: 29300050.
The components excluded from the warranty (such as consumables or parts sub-
ject to wear and tear) are marked on the spare part list.
Serial number and date of manufacturing are shown on the type plate of the unit.
Disposal Information
Within the European Union, units with this symbol should not therefore be disposed of in unsort-
ed domestic waste.
Please contact your local authorities for more information on proper disposal.
- 6 -
6
25
Subject to change

Publicité

loading