Miele professional PM 1210 Manuel D'installation page 4

Notes for installer
Setting up the rotary iron

Dismantle the mounting flaps on the left
and right sides.

Check the roller and front and outside of
the side columns using a level.

Align the machine using the screw-on feet
in such a way that the side columns and
roller are level with each other. In the
process, the feet may be unscrewed a
maximum of 60 mm (approx. 2 3/8").

Counter the screw-on feet according to
the alignment using the nuts (under the
side columns).
Mounting the base (optional)
Mounting the optionally available base can
raise the machine by 100 mm (approx.
3 15/16").

Dismantle the mounting flaps on the left
and right sides.

Unscrew the screw-on feet by the maxi‐
mum amount (> 60mm (approx. 2 3/8")).

Hold the side columns with a suitable aid
and remove the screw-on feet.

Mount the screw-on feet into the base and
push the base under the column.

Screw the base to the base plate of the
machine.
Install the laundry box on the laun‐
dry outfeed table.

During installation, bring the laundry box
into a horizontal position.

Loosen the fastening screws of the laun‐
dry box.

Rotate the laundry box by 180° and mount
with the fastening screws on the laundry
outfeed table.
4
Duct for vapour extraction
 The exhaust air ducting to be laid on-
site must not be channelled into a chim‐
ney or flue already in use for any gas-,
coal- or oil-burning installation. It must al‐
so be laid separately to any exhaust air
duct used for a laundry dryer.
The moist-warm air is to be conducted out‐
side or to a suitable venting duct over the
shortest path possible. Due to the higher air
velocity, the exhaust duct must be laid in
such a way that the air flow is not hindered
(few bends, short lines, well-made connec‐
tions and transitions). Filters and louvers
may not be installed into the exhaust duct.
Since the relative humidity can amount to
up to 100%, suitable measures must be
taken to prevent condensate from flowing
back into the machine. If the machine fan is
not powerful enough to remove the moist
air, a suitably powerful additional fan must
be installed in the shaft or roof outlet on-
site. Supply air must be provided to the
room of installation according to the amount
of exhaust air.
– The connection for the exhaust air duct
for vapour extraction (not available for PM
1210) is located on the rear of the left side
column and has a diameter of 70mm
(2 3/4").
– The exhaust air duct must have an internal
diameter of 70mm (2 3/4").
– With an exhaust air duct leading upwards,
a condensate drain hole (ø 3-5mm
(1/8"-3/16")) must be provided at the low‐
est point to drain the water.
– Adequate ventilation of the installation
room must be ensured.
– The on-site exhaust air duct and exit point
to the outside must be regularly checked
for lint deposits and cleaned if necessary.
– The end of the air duct leading into the
open should be protected against the ele‐
ments (e.g. by a downward angle of 90°).