Miele professional PM 1210 Manuel D'installation page 3

The rotary iron should be commissioned
by Miele Service.
Storage of the machine
The following conditions must be observed
for transport and storage:
Temperature: minimum of - 25°C / 77°F to
maximum of 55°C / 131°F
Humidity: minimum of 5% to maximum of
75%, non-condensing
Maximum storage period: 2 years
Operating conditions
In general, the operating conditions of EN
60204-1 apply.
Temperature and relative humidity
Temperature: 5°C / 40°F - 40°C / 104°F
Relative humidity: 10% - 85%
At 21°C (70°F) ambient temperature, the
maximum permissible relative humidity is
70%.
 This machine should not be operated
in the same room as dry-cleaning equip‐
ment using solvents containing PERC or
CFCs.
Motor sparking may convert solvent va‐
pors into hydrochloric acid which can
lead to consequential damage.
Notes for installer
Installation
The machine is transported to the installa‐
tion site while still in the packaging. Do not
remove the packaging until right before
commissioning.
The machine may be transported or lifted
from the wooden frame only with the lat‐
eral mounting flaps mounted.
First lift the machine at the installation site
by the wooden frame. The suspension
points for lifting hooks/straps are located
under the side columns between the screw-
on feet.
During installation, remember that the clear‐
ance next to and behind the machine col‐
umns must amount to at least 600mm
(23 5/8") so that the side cladding plates re‐
main accessible.
The machine should be set up so that the
light shines parallel to the infeed table as
much as possible.
The clearance in front of the machine must
amount to at least 1.5m (approx. 59") to
prevent a heating of foreign materials (furni‐
ture, walls). There should be a clearance of
at least 1m (approx. 39") above the ma‐
chine.
A base and anchoring means are not neces‐
sary.
During the transport of the machine, pay
attention to its stability. The iron may not
be transported without the wooden frame
(e.g., in case of a move). For a new trans‐
port, lift the ironer onto the wooden frame
and fasten it there.
3