When You Are Finished; After Boating And Maintenance; Motor Care - ProBoat Veles 29 Manuel De L'utilisateur

When You Are Finished

1. Power off the receiver.
2. Power off the transmitter.
3. Disconnect and remove the batteries
from the boat.
Tip: Always remove the canopy before
storage or moisture may allow mold and
mildew to grow in the boat.

After Boating and Maintenance

• Drain water from inside the hull using the drain plug
• Fully dry the inside and outside of the boat, including
the water cooling lines and jacket around the motor.
Remove the hatch before storing your boat
• Repair any damage or wear to the boat
• Lubricate the flex shaft using Pro Boat Marine Grease
(DYNE4200)
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions
Tip: The hook and loop strips in the boat retain water.
To dry them, press on them with a dry cloth.

Motor Care

• Prolong motor life by preventing overheating
conditions. Undue motor wear results from frequent
turns, stops and starts, pushing objects, boating in
rough water or vegetation and boating continuously at
high speed.
29-INCH READY-TO-RUN BRUSHLESS CATAMARAN
1
3
X2
NOTICE: When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as a
car. Doing so can damage the boat.
• Over-temperature protection is installed on the ESC to
prevent circuit damage, but cannot protect the motor
from excessive physical resistance.
• Use Dynamite Precision Oiler (DYNE0100) to service
the motor's bearings. If the bearings get wet, use
water displacement fluid then oil the bearings to
prevent rust or seizure.
2
EN
11