Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Bolt down instructions... continued
5
Move the safe aside to clear both marked spots for drilling.
6
Replace the safe in the desired position, with the holes in
7
the safe aligned with those in the floor.
8
F
The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. Do not drill through the back or sides.
Bolting/unbolting the unit is at the consumer's expense and discretion.
Sentry Group is not responsible for any costs incurred if the unit is to be replaced.
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Bolting Down Your Safe
Drill into the floor:
A
For wood: Using the 9⁄32" drill bit, drill a hole 21⁄2"
(64 mm) deep in each marked spot.
B
For masonry: Using the 3⁄8" drill bit, drill a hole 21⁄2"
(64 mm) deep in each marked spot. Install a masonry
anchor in each hole.
Securing the safe:
A
For wood: Pass each lag screw through a washer,
then through the safe and into a hole. Tighten with
the wrench.
B
For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor.
Tighten with the wrench. Place masonry anchors into
the holes in the floor.
12
Publicité
