Use And Handling Of The Cordless Electrical Power Tool; Service - Parkside PAS 4 A1 Traduction Des Instructions D'origine

f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and accessory
tools etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. The use of
power tools for purposes other than those
intended can result in hazardous situations.
h) Keep the handles and handle surfaces dry,
clean and free from oil and grease. Slippery
handles and handle surfaces do not allow safe
use and operation of the power tool in unfore-
seen situations.
5. Use and handling of the cordless
electrical power tool
a) Charge the rechargeable battery unit using
only the charger recommended by the manu-
facturer. Chargers are often designed for a
particular type of rechargeable battery unit.
There is a risk of fire if the battery charger speci-
fied for a particular type of battery is used with
other batteries.
b) Only the rechargeable battery units supplied
are to be used with an electrical power tool.
The use of other rechargeable batteries may
result in injury or a fire hazard.
c) When they are not being used, store re-
chargeable battery units away from paper
clips, coins, keys, nails, screws or other small
metal objects that could cause the contacts
to be bridged. Short-circuiting the contacts of
a rechargeable battery unit may result in heat
damage or fire.
d) Fluids may leak out of rechargeable battery
units if they are misused. If this happens,
avoid contact with the fluid. If contact occurs,
flush the affected area with water. Seek addi-
tional medical help if any of the fluid gets into
your eyes. Escaping battery fluid may cause
skin irritation or burns.
PAS 4 A1
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries!
■ Protect the rechargeable battery from heat,
for example from continuous exposure to
sunlight, fire, water and moisture. There is a
risk of explosion.

6. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
GB 31 ■
│