Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
BLADE REPLACEMENT
Only use the recommended blade replacement kit for this shear (SKU
8843666).
1.
Remove the lock screws (#30) and lock nuts (#31) and cutter
housing (#29).
2.
Remove the center blade (#33) first then remove the left blade (#35)
and right blade (#32).
3.
Install the new blades.
4.
Replace the cutter housing (#29), lock screws (#30) and lock nuts (#31).
5.
Tighten securely.
OPERATION
Test the shears on a piece of scrap material to determine the cutting
capacity of the blades.
1.
Make sure to hold the shear with both hands safely away from the
blades.
2.
Position the tool near the workpiece, but do not allow the blades to
overlap it. The center blade (#33) will be underneath the workpiece.
The left blade (#35) and right blade (#32) will be above it.
3.
Squeeze the trigger (#8) and allow the blades to reach full speed before
applying the tool to the workpiece.
4.
Feed the blades into the workpiece. Do not force the blades into the
workpiece when cutting. Apply moderate pressure, allowing the blades
to cut without being forced.
5.
Complete the cut before stopping the air shear. This will help keep the
blades from getting caught in the workpiece.
6.
If the tool requires more force to accomplish the task, verify that the
tool receives sufficient, unobstructed airflow (see Specifications). If the
tool still does not have sufficient force at maximum pressure and
sufficient airflow, then a larger tool may be required.
7.
Release the trigger (#8) to turn off the shear. Allow the blades to stop
on their own. Do not press against the blades to stop them.
8.
Turn off the air compressor, then squeeze the trigger again to release
any remaining air pressure from the tool. Disconnect the shear from
the air supply.
Visit www.princessauto.com for more information
Straight Grip Air Shear
8843658
9
Publicité
Table des Matières
